Step #16

Install air solenoid with M4 socket head cap screw on outside of the nonop frame. Connect blue and red wires that were unplugged from motor.

Reference: Images 13 & 14

Run air hose from operator side to nonop side and secure with electrical tape in three places to cross bar. Cover with spiral wrap for air hose protection.

Reference: Above image

Run air hoses thru frame on nonop side. Trim and attach t-fittings: gray to gray and black to black. Plug black hose to top fitting on the solenoid and the gray to the bottom of the solenoid. Secure hoses and solenoid with small nylon tie. From air compressor run large air line up from the bottom of the press to first unit.

Now refer to dampener set up instructions.